Assembly Instructions - ergoCentric upCentric Manual Dei Usuario

Assembly Instructions

Parts
I x2
L x1
R x1
Tools Required
Power Drill with Phillips Head #2 and 5/16"
ratchet or wrench.
6
H x2
J x1
K x1
O x4
S x2
Preparing the Table Top
Step 1:
Lay Protective Matting/sheet
on floor or work surface.
Step 2: Carefully place table down
on work surface with the decorative
laminate facing down and brown
surface facing up
.
Step 3:
If using a tabletop consisting of
two or more pieces, place two pieces
together and attach with connector
plates. Install the connector plates 1"
in from the front edge of the tabletop.
Remember this table top is upside down
so it should be set up in the opposite
way you want it to when flipped right
side up and installed on the frame.
Note:
If you are retrofitting your upCentric Frame onto an existing work
surface and did not order a connector plate set call 1 866 GET ERGO
(438-3746) to order [TABLETOPPLATE].
Assembly Instructions
Step 1: Open the smaller of the two boxes, and remove all contents.
Step 2A: Attach Wire Clips
( PART D )
Step 2B:
Attach Locking Bolts
( PART C )
to both Cross Bar Pieces
( PART I ) .
to both Cross Bar Pieces
( PART I ) .
7