Bosch SHU Instrucciones De Instalación página 10

Figure 12
Figure 13
Junction
Box
Cover
Figure 14
8
Dishwasher Preparation
Plastic Base
Access Panel
Toe
Panel
Remove Screw
Figure 15
DISHWASHER PREPARATION (continued)
Removing the Toe Panel
Regular Toe Panel
The toe panel is loosely attached with tape. Remove the
tape and pull the toe panel away from the dishwasher. Set
the toe panel aside. It will be reinstalled later.
Plastic Base Access Panel and Toe Panel (SHY66C,
SHX99A, SHE66C, SHE99C, SHX57C, and SHV57C
models only)
The plastic base access panel and toe panel are in place
on the dishwasher, but are not attached. Remove the toe
panel first, as shown in Figure 12, then remove the
plastic base access panel, as shown in Figure 12.
Installing the 90° Elbow Fitting
NOTE: The 90° elbow fitting is not supplied with the
dishwasher, and must be purchased separately. If the
dishwasher's hot water supply line is to be copper tubing,
make certain the elbow has a compression fitting.
Apply Teflon tape or other pipe sealant when required.
Orient the hot water supply connection leg of the elbow
toward the channel opening in the dishwasher base. See
Figure 13.
Junction Box Preparation
1 Remove junction box cover (see Figure 14) by lifting
the junction box cover up and off.
2 Remove the strain relief plate by removing the screw
at the back of the junction box, as shown in Figure
15 and sliding the strain relief plate out.
3 Set the junction box cover, strain relief plate, and
screw aside. They will be re-installed later.