Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PREPARING PICKUP TRUCK - TAILLIGHT MOUNTING
NOTE: No changes are necessary for OEM taillight fasteners. The taillight mounting
screws can be removed with an 8mm wrench after liftgate is installed.
NOTE:
will bridge the gap between
liftgate and pickup bed. It is
strips to Liftgate before install-
ing the Liftgate on the truck.
1.
to-end to make 1 long strip at the top
rear edge of the main frame housing
(FIG. 11-1). Position each strip so the
against the back of the housing
(FIG. 11-1). Ensure the top surface
surface the housing.
CAUTION
Before drilling holes in the main
frame housing, ensure there are no
obstructions to drill bit or no items
that could be damaged by drill bit.
2.
mark and drill hole in back of the main
frame housing (FIG. 11-1).
3.
with a #12 x 3/4" long self-drilling
screw (bagged bolts) (FIG. 11-1).
LIFT CORPORATION Sht. 11 of 56 DSG#
INSTALLING FILLER STRIP
M-16-32
MAIN FRAME
HOUSING
FLANGE WITH
SCREW HOLE
POSITIONING FILLER STRIPS
Rev. C Date: 08/13/19
#12 SELF-TAP
SCREW (3 PLACES)
FLUSH
FILLER STRIPS
FIG. 11-1
Tabla de contenido
