realspace 216-230 Manual De Instrucciones página 20

The table operates
irregularly or tilted
The table stops and
can only run
downwards
The table will only
run downwards
even though the
frame is not
overloaded
The frame always
stops at the same
position, before
reaching maximum
height
Not all legs move
when adjusting the
table downwards
/upwards
Is the desk overloaded or is most of
weight on one side?
Visual observation
Is the table at its highest position?
Make sure no objects are in the way
of table while adjusting height.
Make sure the desktop is not
touching any walls.
Visual observation
Make sure no objects are in the way
of table while adjusting height.
Make sure the desktop is not
touching any walls.
Visual observation
Make sure no objects are in the way
of table while adjusting height.
Make sure the desktop is not
touching any walls.
Is the table at its highest position?
The table could be overloaded.
Has the system been programmed to
this specific height?
Is the desk overloaded or is most of
weight on one side?
Make sure no objects are in the way
of table while adjusting height.
Make sure the desktop is not
touching any walls.
The leg that does not move could be
defective or the cable connection for
the leg is not ok.
Remove some of the load and
perform again.
Distribute load evenly.
Perform resetting.
When the table has reached the
maximum height, it can only run
downwards.
Move all objects away from table while
adjusting height.
Move the table away from any walls.
Remove some of the load and
perform again.
Distribute load evenly.
Move all objects away from table while
adjusting height.
Move the table away from any walls.
Perform resetting.
Move all objects away from table while
adjusting height.
Move the table away from any walls.
When the table has reached the
maximum height, it can only run
downwards.
Remove some of the load and
perform again.
Distribute load evenly.
Perform resetting.
Remove some of the load and
perform again.
Distribute load evenly.
Move all objects away from table while
adjusting height.
Move the table away from any walls.
Check all connections and make sure
assembly steps 3, 5 and 6 were
followed correctly. If the leg will not
move after resetting, it is defective.
Damaged parts must be
exchanged-contact customer service.