Final Steps - KTM Power Parts 76008915144 Instrucciones De Montaje

19
21
14
6
27
5 3 6
17
20
16
20
- Remove the original turn signal (26) from the original license plate holder
(25).
26
- Mount the tail light (19) (included) on the tail light holder (15).
- Mount the original turn signal (26) with the tail light holder (15) on the
preassembled license plate holder.
26
- Mount the preassembled license plate holder (14) on the rear with the screws
M8x20 (11) (25 Nm, Loctite 243).
- Mount the adhesive guide (13) (included) on the underside of the sub-
frame.
11
Installation of license plate light with national type approval (NTA):
- Remove the original license plate light (27).
- Mount the license plate light adapter (17) with the countersunk screws
M4x8 (8) (included) and nuts and washers (included with license plate
light).
- Mount the original license plate light (27) on the license plate light adap-
ter (17) with the cap head screw M5x14 (5) (included), washer A5.3 (3)
(included) and nut M5 (6) (included).
- Mount the original reflector on the license plate holder.
- Route the cables of the license plate light, tail light, and turn signals through
8
the adhesive
Installation of license plate light without national type approval (NTA):
- Mount the license plate light (20) (included) WITHOUT the license plate
light adapter
and nuts (included).
- Route the cables of the license plate light, tail light, and turn signals through
the adhesive guide.
NOTE:
When using the license plate light (20) (included) with a license plate frame, include
the bushings (10) (included).

Final steps

- Connect the license plate lamp.
- Connect the tail light.
10
- Connect the turn signal.
- Mount the passenger seat.
Check that the turn signals on the left and right, the license plate light, and the
tail light/brake light are functioning properly.
guide.
(17) on the license plate support (16) with the washers