Stiga T8615 Manual Del Usuario página 6

10. Attach end of linkages #4 with two holes to INSIDE of Leg #2 as shown in Detail
G & Detail H. Secure through end hole with screws #23, locknuts #15 and
plastic spacers #31. Tighten hardware snug enough to keep table stable but do not
overtighten. Tubes must pivot freely.
11. On one side of the table attach slotted end of safety strap #6 to INSIDE
of Leg #2 using one bolt #14, one spacer #30, one washer #24, and
one hex nut #15. Tighten hardware until snug but do not overtighten.
Tubes must pivot freely. See Detail H.
12. Attach other end of safety strap #6 to OUTSIDE of linkage #4
using one bolt #9, one washer #24, one spacer #30, and
one hex nut #15 as shown in Detail H.
Important! Do NOT put other safety strap #6 on this
table half. It will be installed on second table half later.
13. Tap caster sockets #12 into U-support #7 until flange on
sockets touches the edge of the tube. DO NOT HIT CASTER
SOCKET DIRECTLY WITH A HAMMER! SET A PIECE OF
WOOD ON CASTER SOCKET AND HIT PIECE OF
WOOD TO DRIVE CASTER SOCKET INTO U-SUPPORT.
14. Insert casters #11 into caster sockets #12.
See Figure 5A.
4
2
30
14
24
9
24
23
Detail H
31
6
First Table Top
Figure 5A
Figure 3
Figure 3
15
6
4
30
Detail G
15
11
12
7
4
15
4
2
23
31