Assembling The Tool; Before Starting The Tool; Starting And Stopping - 3M PN 64392 Manual Del Usuario

1 - Identifi cation plate
2 - ON/OFF switch
3 - Electronic rpm regulation
4 - Spindle
5 - Auxiliary handle
6 - Heat protection
7 - Buff er pad tapered ring nut
8 - Buff er pad (optional)
10 - Wrenches (17 mm spanner and pin spanner)
11 - Motor ventilation slots
13 - Switch locking button
14 - Spindle lock
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been damaged during storage or transport;
- the tool is complete; check that the number and type of components comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in the table and that indicated on the tool identifi cation plate reproduced and
explained in this manual.
- screw in the handle (5); the handle can be mounted on the left or right of the tool body;
MOUNTING THE BUFFER PAD
- Insert the buff er pad (8) on the spindle (4);
- screw on the tapered ring nut (7) and tighten it using the pin spanner, preventing the spindle from moving using the 17 mm spanner or using the spindle lock (14).
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly, test with the power supply disconnected;
- all the parts of the tool have been assembled in the proper manner and that there are no signs of damage;
- the ventilation slots are not obstructed.
- Starting: push the lever of the switch (2) towards the body of the tool; if the tool is to be locked in the ON position, press button (13) at the same time
and keep it pressed while releasing lever (2), thus locking the switch.
- Stopping: release the lever of the switch or, if locked in position, push the lever to release the lock button.
3M Instruction Manual
75-078_Polisher.indd 5 75-078_Polisher.indd 5
PARTS OF THE TOOL
14
INITIAL TOOL RECEIPT CHECKS

ASSEMBLING THE TOOL

BEFORE STARTING THE TOOL

STARTING AND STOPPING

3
EN
13
12.03.2010 12:48:24 12.03.2010 12:48:24