Polk Audio PSWi225 Manual Del Propietário página 4

AC POWER CONNECTION AND AUTO ON/OFF
Off/Auto/On Switch
Your PSWi225 Subwoofer uses a 3-position power switch, which
selects your subwoofer's operational mode. The three modes are:
Off, Auto and On.
Off
With the switch in this position, the subwoofer is inactive.
Auto
In the "Auto" position, your subwoofer automatically turns on when it senses
an audio signal and the LED located on the back of the subwoofer will turn green.
We recommend the "Auto" mode if your subwoofer is always receiving
power (i.e., if it's plugged into a wall outlet). When no signal is present, the
subwoofer will enter a "waiting" state after 15 minutes and the LED will turn red.
On
The subwoofer is always on and fully active in this mode. The LED on the back
of the subwoofer will be green. This mode is best if the subwoofer is plugged
into a switched power outlet.
Note: You may want to leave your subwoofer unplugged during extended
periods of non use, such as during a vacation.
4 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
CONNECTING THE SUBWOOFER TO
THE SYSTEM—HOOKUP OPTIONS
IMPORTANT NOTE: USE ONLY ONE OF THESE OPTIONS.
NEVER COMBINE HOOKUP OPTIONS.
OPTION #1 Receivers that include a "SUB OUT" feature—
the most common hookup method with Dolby Digital
SUB-OUT
CENTER
WIRELESS TRANSMITTER
WIRELESS SUBWOOFER
The two switches
must be set to the
same position for the
subwoofer to receive
a signal.
• Connect a single RCA cable from the "SUB OUT" of your receiver
to the LFE input of the transmitter.
• Connect all other speakers directly to the receiver.
• Adjust your receiver's speaker configurations as follows:
Front Speakers = SMALL
Center and Surrounds = SMALL
Subwoofer = ON, YES, or PRESENT
• Depending on your front speakers' bass output capabilities, set the crossover
frequency on the receiver to 80Hz for tower and bookshelf speakers (speakers
with a woofer 5 1/4" in diameter or larger) and 100-120Hz for satellite speakers.
Consult your receiver's owner's manual for instructions.
® and DTS ® receivers.
RECEIVER
FRONT REAR
DC 5V 1A