Electrical Connections - Atec Venice Instrucciones De Montaje

Pag. 10 di 36
3.6 ELETTRICAL CONNECTIONS
Use a four-wire cable for connecting the camera to the monitor.
Terminals 1, 2, 3, 4 on the rear of the camera (private entrance) must be connected to monitor terminals 5, 6, 7, 8.
A Venice camera connected to a single additional six-button panel can be powered by a 14÷16Vdc 1A transformer.
If more than one additional panel is connected, the Venice camera must be powered by a 14÷16Vdc 2A transformer.
The wiring diagram shows the connection to a door release. For an automatic gate connect terminals 7 and 8 to the common contact and the open
control terminals on the gate control panel.
NOTES:
1 - In case of installing the unit at high voltage area, use the coaxial cable with metal pipe.
2 - Connecting monitor to camera, do it after setting power to OFF mode. After you have completed all connections, set power to ON mode.
Power supply
14÷16Vdc 2A
230Vac 50/60 Hz
Electric lock
Electric lock power supply
For an RIB automatic gate, Venice camera terminals 7-8 connect to clamps 8-9 or 8-K on the RIB controller.