Advanced Programming - Grote 79100 Guia De Instalacion

This section is OPTIONAL. Most applications will not require any Advanced Programming.
You should only need to reference this section if you require specialized programming.
CHANGING COLOR ASSIGNMENTS FOR EACH ENABLE
(applies only to Patterns 1-10, Steady Burn, and Cruise)
When shipped, each Enable wire has one color assigned to it. The table below
shows the default factory settings.
To reprogram the color assigned to each Enable, or to assign multiple colors to
one Enable, proceed as follows:
 Connect the BLACK wire to Ground.
 Connect the WHITE wire and only the Enable wire that you wish to
reprogram to Power.
 Briefly touch and release the GREEN wire to Ground to scroll through the
color combinations listed in the table below.
 Disconnect the WHITE wire from Power after 1 second.
Changing COLOR ORDER for each enable
(applies only to Patterns 11-18 / 3-Phase Patterns)
When programmed for Patterns 11-18, each Enable wire has a default "Color Order"
assigned to it (the order the colors are rotated through). By default, each Enable
Wire has only one color assigned to it.
Using this programming option you can change the order and/or replace individual
colors from the 3-Phase pattern. This can be useful if you want to utilize only one or
two colors for a particular Enable, or if you have two synchronized lights and you
would like a different color flashing on different lights.
To reprogram the Color Order assigned to each Enable, proceed as follows:
Connect the BLACK wire to Ground.

Connect the WHITE wire and the Enable wire that you wish to reprogram to

Power.
Hold the GREEN wire to Ground to for 3 seconds until the light flashes once

then release it. The Color Order will scroll to the next combination listed in the
table to the below.
Repeat the process with the GREEN wire until you advance to the

combination you desire.
Disconnect the WHITE wire from Power after 1 second.


Advanced Programming

STOP !!
-4-
FACTORY DEFAULT ENABLE WIRES
◄ YELLOW w/BLACK - Enable 3
◄ YELLOW w/GREEN - Enable 2
◄ YELLOW w/RED - Enable 1
DEFAULT ENABLE WIRE COLOR
ORDERS FOR 3-PHASE PATTERNS
◄
YELLOW w/RED - Enable 1
◄
YELLOW w/GREEN - Enable 2
◄
YELLOW w/BLACK - Enable 3