Idiomas disponibles
Idiomas disponibles
use the provided wrench to tighten the screws completely.
Hand tighten until spring washer is
seated and pad fits firmly into track
(some movement is acceptable).
Tighten to final torque (20in-lbs) .
If control tower does not fit into
landing pad after final tightening,
loosen bolt in 1/2 turn increments
until it can be installed.
REAd thESE wARningS!
Make sure Control Towers or Skyline
Towers, with bars installed, seat
completely with Landing Pad. If they
do not seat properly, repeat step 6 with
special attention to pulling rear side of
landing pad toward you as you tighten
the special nuts.
Continue with Control Tower or Skyline Tower installation.
1035590B-3/9
Be sure all hardware is secured
according to instructions. Failure to
perform safety checks before driving
away can result in property damage,
personal injury, or death.
Attachment hardware can loosen over
time. Check and tighten if necessary,
before each use.
• do not EXCEEd wEight limit:
165 lbs. (75 kg)
• Consult your YAKimA dealer or
fit list to see load limitations for
accessories.
Remove your YAKIMA rack and
accessories before entering automatic car
washes.
