Foreword; Precautions; Installation - Marantz SR4320 Guia Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79

FOREWORD

This section must be read before any connection is made to the
mains supply.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your area.
SR4320 can be powered by 230 V AC only.
COPYRIGHT
Recording and playback of any material may require consent. For
further information refer to the following:
Copyright Act 1956
Dramatic and Musical Performers Act 1958
Performers Protection Acts 1963 and 1972
any subsequent statutory enactments and orders
ABOUT THIS USER GUIDE
Refer to the figures on page iv of this user guide. The numbers on the
figures correspond to those in the text. All references to the
connections and controls that are printed in BOLD type are as they
appear on the unit.

PRECAUTIONS

The following precautions should be taken when operating the
equipment.
GENERAL PRECAUTIONS
When siting the equipment ensure that:
the ventilation holes are not covered;
air is allowed to circulate freely around the equipment
it is on a vibration free-surface;
it will not be exposed to interference from an external source;
it will not be exposed to excessive heat, cold, moisture or dust;
it will not be exposed to direct sunlight;
it will not be exposed to electrostatic discharges
Never place heavy objects on the equipment.
If a foreign body or water does enter the equipment, contact your
nearest dealer or service center.
Do not pull out the plug by pulling on the mains lead, hold the plug.
It is advisable when leaving the house, or during a thunderstorm, to
disconnect the equipment from the mains supply.
PRECAUTIONS IN CONNECTION
• Be sure to unplug the power cable from the AC outlet or turn off the
POWER switch before proceeding with any connection.
• Connect one cable at a time observing the "input" and "output".
This will avoid any cross connection between channels and signal
inputs and outputs.
• Insert the plugs securely. Incomplete connection may result in
noise.
• Prior to connecting other audio and video equipment to the
SR4320, please read their owner's manuals.

INSTALLATION

If this unit or another electronic device incorporating a
microcomputer is used at the same time with the tuner or television,
picture disturbance or noise may occur. In such a case, install the
unit according to the following guide points.
• Separate the unit as far as possible from the television.
• Place the antenna wire for the tuner or TV apart from the power
cable and audio and video connection cables of this unit.
• Since the phenomenon is likely to occur when using an indoor
antenna and/or 300-ohm feeder wire, we recommend using an
outdoor antenna and 75-ohm coaxial cable.
CAUTIONS ON INSTALLATION
For heat dispersal, leave at least 20 cm/8 inch of space between the
top, back and sides of this unit and the wall or other components.
• Do not obstruct the ventilation holes.
2
20 cm (8 ins.)
RECEIVER SR4320
MULTI - JOG
VOLUME
SPEAKERS
A
B
DOWN
UP
DISPLAY OFF
CLEAR
MEMORY
TUNING/PRESET
F/P
MODE
JOG MODE
SPEAKERS
S-DIRECT
SLEEP
MUTE
STANDBY
POWER ON/OFF
PHONES
DVD
VCR
DSS
CDR/MD
TAPE
CD
PHONO
TUNER
20 cm (8 ins.)
Tabla de contenido

Solución de problemas

loading

Tabla de contenido