Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Switching the Walkie-Talkies Off
Press and hold the
seconds� The walkie-talkie is switched off and the
display goes out�
Operating the Walkie-Talkies
When you want to communicate through the walkie-
talkies, you must switch the walkie-talkies on and
set them to the same channel�
To ensure a connection is established successful-
ly, the walkie-talkies must be within the reception
range�
The elements selected in the menu flash when you
are defining the respective setting.
Sending and Receiving Signals
1
Press and hold the
display� The walkie-talkie is in Transmit mode�
2
Hold the walkie-talkie close to your mouth and
speak into the microphone�
All the walkie-talkies which are within range and
are switched to the same channel receive your
message�
appears in the display�
3
If you want to answer a signal received, press
PTT
the
key and speak into the microphone�
Scanning the Channels
Before scanning all the channels to receive possible
radio signals within range of your walkie-talkie, en-
sure that the setting in the Subchannel menu is 0F�
1
Press the
key� The walkie-talkie scans all
the channels in succession�
2
If you want to retain a channel, press the
key again�
key for about three
PTT
key�
appears in the
If you want to establish communication with other
walkie-talkies, ensure that all the walkie-talkies in
question are using the same channel and subchan-
nel�
Setting the Channel
The walkie-talkies use free channels� The walkie-
talkies within range which are set to the same chan-
nel can receive signals� Also observe the information
regarding the subchannels if you want to ensure that
third-parties cannot participate in your communica-
tion�
1
Press the
key�
2
Use the
and
quired channel�
Confirm your input by pressing the
3
Setting the Subchannel (Subcode)
CTCSS Code
In order to enable communication via a subchannel
(CTCSS code), the walkie-talkies communicating
with each other must be set to the same channel and
same subchannel�
1
Press the
key twice�
display�
2
Use the
and
required subchannel�
Select the setting 0F if you do not wish to use a
subchannel�
appears in the display�
keys to set the re-
PTT
key�
appears in the
keys to select the
15
Tabla de contenido
