Troubleshooting - Stanley Fatmax FME190 Traducción De Las Instrucciones Originales

ENGLISH
In particular clean the air vents (1) after every use with a
u
cloth and brush.
Remove stubborn dirt with high pressure air (max. 3 bar).
u
Note: Do not use chemical, alkaline, abrasive or other
aggressive detergents or disinfectants to clean this product as
they might be harmful to its surfaces.
Check for worn or damaged parts. Replace worn parts
u
as necessary or contact an authorised service centre for
repair before using the product again.
Maintenance
Before and after each use, check the product and
u
accessories (or attachments) for wear and damage. If
required, exchange them for new ones as described in this
instruction manual. Observe the technical requirements.
Repair
This product does not contain any parts that can be repaired
by the consumer. Contact an authorised service centre or a
similarly qualified person to have it checked and repaired.
Storage
Switch the product off and disconnect it from the power
u
supply.
Clean the product as described above.
u
Store the product and its accessories in a dark, dry, frost-
u
free, well-ventilated place.
Always store the product in a place that is inaccessible to
u
children. The ideal storage temperature is between 10°C
and 30°C.
We recommend using the original package for storage or
u
covering the product with a suitable cloth or enclosure to
protect it against dust.
Transportation
Switch the product off and disconnect it from the power
u
supply.
Attach transportation guards, if applicable.
u
Always carry the product by its handles (2).
u
Protect the product from any heavy impact or strong
u
vibrations which may occur during transportation in
vehicles.
Secure the product to prevent it from slipping or falling
u
over.
8
(Original instructions)

Troubleshooting

Suspected malfunctions are often due to causes that the
users can fix themselves. Therefore check the product using
this section. In most cases the problem can be solved quickly.
Problem Possible Cause
Product does not start Not connected to power
supply
Power cord or plug is
defective
Other electrical defect to
the product
Product does not Extension cord not suitable
reach full power for operation with this
product
Power source (e.g.
generator) has too low
voltage
Air vents are blocked
Unsatisfactory Stirrer is worn
result
Stirrer not suitable for
material to be mixed
Solution
Connect to power
supply
Check by a specialist
electrician
Check by a specialist
electrician
Use a proper
extension cord
Connect to another
power source
Clean the air vents
Replace with new
one
Use proper stirrer