Babyhome Emotion Instrucciones Para El Uso página 20

To open up the harness, press
both buttons located on either
side of the harness restraints
together.
Regulate the belts so they are
snug on your child. To adjust
the length of the belts, slide the
buckles up or down. Remember,
too, that the shoulder belt has two
lengths.
Reclining positions
The Emotiont pushchair comes
with a mechanism located behind
the seat to regulate the reclining
positions. This mechanism works
as follows:
To raise the seat, pull the strap
parallel to the seat, as shown
in illustration 14a. Stop pulling
when the seat reaches the de-
sired position or when the mecha-
nism reaches as far as it can.
To recline the seat, lift the knob
EN
and gently lower the seat to
20
the desired position. Once you
release this knob, the seat will
remain in place (illustration 14b).
Remember that pulling the strap
in one direction is not recom-
mended and forcing the knob
can lead the mechanism to work
improperly.
Use of the hood
Once the hood is attached, it can be
folded or unfolded using the piece lo-
cated on each side (illustration 15a).
The upper part of the hood has a
window that can be uncovered by
pulling back the fabric covering it.
You can remove the hood by mov-
ing the two anchoring pieces in
the direction shown in close-up 2
of illustration 15b.
Putting on the rain protector
To put on the rain protector,
release the security latch located
on the right joint of the hood (see
close-up of illustration 16). Slide
the protector along the hood
chassis using the knobs located
on either side of the protector (il-
lustration 16).
Then attach the rain protector to
the chassis using the attachment
systems provided (Velcro and
fasteners).
To remove the rain protector, do
the opposite: remove the attach-
ments and slide the protector
along the rail until it is completely
free.
Putting on the screen
The screen should be installed
following the same directions as
for the rain protector.