Commercial Electric 50232161 Guía De Uso Y Cuidado página 8

surface Mounting (continued)
2
Preparing the power supply box for mounting
□ Remove the knock-out near the end of the power supply box.
□ Attach one hook from each of the two cable sets (BB) to the hanging holes on the power supply box.
□ Close the open hooks attached to the power supply box with pliers. Do not close the open S-hooks at the bottoms of the
cable sets.
Power Supply Box
Hanging Holes
3
Attaching the cover plate
□ Feed the electrical wires from the electrical box through the cover
plate (AA).
□ Secure the cover plate (AA) to the electrical box with the electrical
box screws (DD), but do not tighten them fully. Screw them into
the cover plate (AA) until there is about 3/8 in. between the cover
plate (AA) and the underside of the screw head.
Knock-out
Hole
BB
Hanging
Power Supply Box
Holes
8
AA
DD