ZUMEX Speed Pro Manual De Usuario página 26

Feeder basket (13)
The feeder basket can be removed and re-attached facing guides and making a slight movement
until it stops (Fig. 1).
Feeder basket door (14)
The feeder basket has an easy-to-open door to make it easier to fill the basket up with oranges
(Fig. 1).
Power cable (15)
Check cord is plugged in the machine and protected with cord retainer (Fig. 1).
Protector cable with 3 screws (16)
Check protector holds cable with three screws (Fig. 1).
Self Service/Tank Tray gasket 6.3 x 3.5 (17)
If required, this gasket can easily be removed for cleaning and fitted back in by hand (Fig. 1).
Tray bolt (18)
This component only has to be handled if a spare SS Juice container (40) or Tank juice container
(50) is requested (Fig. 1). After inserting the spare container, adjust the bolt from the rear to
adjust the container position.
1Step kit (19+)
This device allows for easy insertion and removal of the pressing units and peel ejectors in just one
step (Fig. 1+).
Before installation remember to insert the Blade holder S +plus (9+).
To install, line up the pressing units with the shafts and adjust their position while sliding them in.
Use the central knob to attach the device to the machine.
Note: To remove simply reverse the process.
Assembly of the 1Step Kit (19+)
a) Place the rear holder (19.2+) on a surface. The metal ejector holders should be face down.
b) Match up the lower and upper pressing units (4 and 5). Line up the circular bases of
the pressing units with the holes on the holder. Note that the faces of the pressing units
are different.
Ensure to mount them as shown in the figure.
d) Line up the protruding cones of the pressing units with the four circular bushes on the
front holder (19.1+).
e) Join both holders with the plastic securing knob (6).
c) Turn the 1step kit 180º and line up the ejectors (7 and 8) with the ejector holders,
inserting the extractor blade into the seal of the lower pressing unit. Ensure that both
holders are inside the ejector channel as shown in image 4.
Disassembly of the 1Step Kit (19+)
c) From the position shown in image 4, pull the ejectors (7 and 8) sideways to remove them
from the metal holders.
a) Turn the kit 180º and unscrew the plastic securing knob (6), which is located behind the
pressing units and holds both metal holders (19.1+ and 19.2+).
b) Carefully pull the front holder (19.1+).
c) Separate the lower pressing unit (4) and the upper pressing unit (5).
Note: To clean the unit, refer to the Cleaning section.
Plastic Juice Container (30)
Make sure that the sealing gasket is correctly mounted on the container (Fig. 11). Then place the
container in the machine. Line up and place under the container on the four lugs that you will see
on the machine (Fig. 2).
Plastic inner filter (31)
Place on the inside of the juice container (Fig. 2).
EN
49