Installation And Safety Instructions - Kathrein EXR 58/ECO Manual De Instalación

Sat-IF distribution system
Multi-switch
Features
Multi-switch for distribution of four Sat polarities and

terrestrial signals to eight connections
Only one drop cable per receiver needed (two for twin

receivers)
Independent horizontal/vertical, low/high selection from

each receiver
Switching via coaxial cable at 14/18 V and 0/22 kHz

signal frequency
Integrated amplifi er for low attenuation in Sat range

Integrated pre-emphasis to equalise cable attenuation

Terrestrial signals also receivable when the Sat

receiver is switched off
Terrestrial range: 5-862 MHz

High decoupling between outputs

LNB remote feed via "horizontal low input". All other

inputs are voltage-free (enabling operation with UAS
585)
The connected LNB is powered through the receiver.

If all receivers are switched off, the system requires no
electricity.
In order to enable long-term power supply to the LNB

(e.g. for cascading with loop-through multi-switches), the optional plug-in power supply NCF 18 (not included
in delivery scope) can be inserted into the socket
labelled "DC".


Installation and safety instructions

• The equipment described is designed solely for the installation of satellite reception systems.
• Any other use, or failure to comply with these instructions, will result in voiding of warranty cover.
• The equipment may only be installed in dry indoor areas. Do not mount on or against highly combustible
materials.
• The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm
• The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with.
• Fixings: Screws, max. Ø: 4 mm
• Connectors: RF plug 75 Ω (series F) to EN 61169-24.
• Unused RF connections must be terminated with 75 Ω resistors (e.g. EMK 03).
suitable for DVB-T
1 / 2
EXR 58/ECO 20510051
).
2