Getting Started; Usage - Marmitek MegaView 90 Modo De Empleo

4 Getting started

In order to check proper functioning of the system, it is advisable to test the
set-up first, using a short CAT-5e/6 cable.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (Blu-ray disc player, TV Decoder, Media
Centre PC, etc.) to the MegaView 90 transmitter [1], using an HDMI
cable (not provided).
3. Connect your HDTV or HD projector to the MegaView 90™ receiver [3]
with an HDMI cable to HDMI OUT.
4. Use one CAT5e/6 Ethernet cable to connect the MegaView 90's
transmitter to the receiver [4].
The MegaView 90™ can either be connected by using a single

cable, or through an existing home network (LAN) in combination
with network switches and routers.
5. Repeat steps 4 and 5 to connect additional receivers.
6. Connect the power adapter [5] to the '5VDC' connection on the
MegaView 90™ and plug the adapters into a socket.
Attention! Do not place the MegaView 90™ transmitter or receiver in an
enclosed space, such as a TV cabinet or equivalent. Provide adequate
ventilation to ensure that the product is functioning properly and to protect
against overheating.
4.1

Usage

1. Switch on the HDMI source (e.g. TV Decoder or Media Centre PC).
2. Switch on the display device (for instance HDTV or projector) and
select the appropriate input. Usually you will do this by pressing the A/V
or EXT button of your remote control.
3. You will receive images from the connected A/V device immediately.
4. When everything is working normally, the 'DATA' LED on the receiver
will flash rapidly and the 'LINK' LED will light up continuously.
6 © MARMITEK