Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: When the machine is running, please maintain a constant water supply. Without water
circulation will damage the sealing rings of the machine.
WARNING: It is necessary to turn on the spray lance within one or two minutes after the machine has
been started. Otherwise, the temperature of the circulating water within the machine will soon rise to a
critical point, which will cause damage to the sealing rings inside the machine.
WARNING: Don't start and run the machine in a place excessively cold so as to prevent the machine from
the freezing current.
WARNING: This machine has been designed for only using cleaning water, do not use corrosive chemicals.
WARNING: High-pressure jets can be dangerous if subject to misuse. The jet must
not be directed at persons, animals, live electrical equipment or the machine itself.
Pressure washers should not be pointed at tire walls, as it may be possible to
damage them.
WARNING: Disconnect from the electrical power supply before carrying out user maintenance. If the
mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly qualified
person to avoid a hazard.
WARNING: When the machine is moving and installing, the machine must be in flat. When moving the
machine, pulling the handle to move it.
WARNING: Connect to the water supply. The machines are not suitable for connection to potable water
mains. Connect the machine to the water supply. (It can be a water container). Make sure the inlet water
pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at least 5 M long. Do not use the pipe
if the pipe is damaged. If you want connect this machine to potable water mains, you must install a
backflow preventer in the water pipe to prevent dirty water flow back to the drinking water system. The
backflow preventer shall comply with EN 60335-2-79 ANNEX AA.
OPERATING INSTRUCTIONS
! This unit is to be connected to a cold-water source ONLY.
! The motor of this pressure washer will NOT run. It will only operate when the trigger is squeezed.
Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
-
Connect nozzle and nozzle extension.
-
Check gauze filter is clear of any blockage.
-
Connect the water supply hose.
-
-
Check that the hose has no kinks in it.
-
Turn on water and check for leaks.
Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
-
Plug in machine and turn on switch.
-
Unlock trigger and use the pressure washer.
-
28
Tabla de contenido
