Tabla de contenido
OPERATION
Stopping the Engine
1. Move the throttle to the minimum position
2. Move the steering controls outward.
3.
blade switch down.
4.
button on the lever and pulling the lever
upward to the transport position.
5. When the machine is standing still, engage
button and pulling the lever upward.
to idle at least 60 seconds to attain a normal
the engine for longer periods.
6.
leaving the mower to prevent unauthorized
use.
IMPORTANT INFORMATION Leaving the
ignition switch in a position than OFF will cause
Operating on Hills
Driving on Slopes
in the Safety section.
• Use the slowest speed possible before starting
up or down hills.
• Avoid stopping or changing speed on hills.
•
•
•
mower and press forward to regain forward
motion.
•
WARNING! Do not drive the mower on
terrain that slopes more than 10 degrees. Mow
slopes up and down, never side to side. Do not
drive across slopes. Avoid sudden directional
changes.
18
Mowing Tips
•
to avoid collisions.
• Begin with a high cutting height and reduce
it until the desired mowing result is attained.
after moderate growth.
• For best cutting performance, mow grass over
high; the second to the desired height.
•
is not too long and dense, the driving speed can
mowing result.
•
increased as a higher operating speed can be
used without poor mowing results.
•
or two rounds, mow in the opposite direction
•
lawn, clumps build, and grass clippings fasten
under the cowling.
•
after each use. When cleaning, raise the mower
• Use compressed air to clean top surface of
engine and electrical components.
•
MANTENIMIENTO
Ajustar el cable del acelerador
Las ruedecillas (cada 200 horas)
3)
2)
2)
2) 4)
= Descrito en este manual
= No se describe en este manual
= Consulte el manual del fabricante del motor
1)
Primer cambio, después de 8 a 10 horas.
Cuando se trabaja con una carga pesada
o a temperaturas ambiente elevadas, el
reemplazo se debe realizar cada 50 horas.
2)
reemplazo.
3)
4)
Use siempre protección
ocular cuando esté cerca de las
INFORMACIÓN IMPORTANTE
utilice el cortacésped con sistema para hacer
AL
UNA
25
50
100 300
3)
No produzca un corto
en contacto con ambas terminales al mismo
La terminal positiva debe conectarse primero
INFORMACIÓN IMPORTANTE No abrir o
agregar ni revisar el nivel del electrolito.
Use siempre dos llaves para los tornillos de
las terminales.
Utilice gafas de protección
lavado.
55
Tabla de contenido
