ANSMANN AES 2 Manual Del Usario página 7

iMPORtAnt nOtES
> Only connect entertainment electronic devices (e.g. TV units, HiFi systems) to the IR mains socket
that can be used with an infrared remote control!
> The max. standby power consumption of all connected devices should not exceed 30 Watt, otherwise
the devices can only be disconnected from the mains power by IR-timer but not by the standby-mode!
> Video, DVD recorders and other recording devices are not suitable for connection to the IR mains
socket, because the mains power will be cut completely and will reset the recorders timers and set up!
OPERAtiOn
1. Select the desired operating mode (see drawing):
A. Switch position "Standby": If the connected device is one minute in standby, the IR mains socket
disconnects it completely from mains. 60 seconds before disconnecting it, the LED [E] will flash. The
flashing ends when the mains cut-off is completed or when the connected device had been turned on
with the remote control during this time and taken out of standby.
B. Switch position "IR-timer + Standby": In addition to the above mentioned standby- power cut-off,
there is an automatic countdown timer activated, which disconnects all operating devices attached
if the remote control has not been detected within one hour. Any IR-signal from the remote control
will restart the timer again. Power cut-off will be indicated 60 seconds before the timer runs off by
flashing of the LED [E]. Within this time you may prevent cut-off by pushing any button of the remote
control. The timer will then be restarted.
2. Plug the IR mains socket into a correctly fitting mains socket and connect your device with the IR
mains socket. You may also connect several devices by plugging in a multi-way socket to the IR mains
socket, but please take care that the maximum load is not exceeded!
3. Place the sensor [D] correctly so that it can detect the IR-signal of the remote control.
4. Press and hold the "Reset" button [C] for 2 seconds. After this your IR mains socket will be ready.
5. Press any key on your remote control (preferably the key with which you turn on your device) and
hold for 2 seconds. The red LED [E] next to the sensor will light up for a short period and the
connected device is ready for use.
6. If your device is still in standby mode, turn it on as usual to use it. Any IR signal from your remote
control will be indicated by the red LED [E].
As soon as the IR mains socket has disconnected devices from mains, it cuts-off itself completely and will
use power no longer thanks to the intelligent Zero Watt Technology (0 Watt). The socket back-up power
while disconnected from mains is provided by a battery pack built into the socket. At first time operation
the mains cut-off will be after the internal battery is fully charged.
EniViROnMEntAl nOtES
This IR mains socket contains a lithium battery pack. Do not dispose this product into the normal
household waste. Please return to your dealer or nearest recycling centre or collection point. Please
note the current applicable regulations. In case of doubt contact your recycling centre. Please recycle all