ResMed Quattro Air NV Manual Del Usuario página 10

4. Bring the lower straps below your ears. Loop the headgear onto the
frame and clip the quick release together.
5. Undo the fastening tabs on the lower headgear straps. Pull the straps
evenly until the mask sits firmly on the chin and reattach the fastening
tabs.
6. Turn on your device so that it is blowing air. Connect the air tubing
from your device to the elbow. Attach the elbow to the mask by
pressing the side buttons and pushing the elbow into the mask.
7. Undo the fastening tabs on the upper headgear straps. Readjust the
straps evenly only enough that a seal is achieved and reattach the
fastening tabs. Overtightening may cause leaks.
8. Your mask and headgear should be positioned as shown.
Removing your mask
There are two ways to remove your mask.
Removing your mask normally
1. Unclip the quick release from the frame by pinching the buttons on
the sides. You can also remove the lower headgear strap from the
hook.
2. Pull the mask away from your face and back over your head.
Removing your mask using the quick release cord
1. Pull the quick release cord down. The quick release clip separates
from the mask.
2. Pull the mask away from your face and back over your head.
Disassembly
1. Unhook the upper headgear straps from the frame. There is no need
to undo the fastening tabs.
2. Remove the elbow from the mask by pressing the side buttons and
pulling the elbow away. Remove the elbow from the air tubing.
3. While holding the bottom of the hook, pull the corner of the frame
slightly away from the side of the mask.
4. Remove the frame from the rest of the mask.
English 3