HQ-Power VDP201GLD Manual De Instrucciones página 2

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (see "7. Technical Specifications"):
1. Unscrew the fuse holder on the rear panel with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten it with the screwdriver.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The device must be positioned in a way that laser projections lie 3 metres above the audience.
• Any ignorance of the safety guidelines will not only be very dangerous, but will also break existing regulations. The
user is responsible for positioning and operating the laser in such a way that the laser represents no danger at all.
The manufacturer will not accept liability for damages caused by the misuse or incorrect installation of this device.
• ! Never stare into the laser beam!
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
The device has 4 operation modes:
a. Auto Mode
• The unit runs a built-in program that changes the laser effects automatically.
• Set DIP switch pin 10 to ON, all others to OFF
b. Music Mode
• The unit runs a built-in program that reacts to the music
• Set all DIP switches to the OFF position
VDP201GLD 2 VELLEMAN