Stop The Engine - STERWINS PCS 38 Manual De Instrucciones

2. Press the primer bulb a few times until you notice a slight pressure (aprox. 5 times).
3. Pull of the air handle until (a) position. The stopper will be closed and the accelerator´s
handle will remain accelerated
Air´s handle
4. While you hold the unit of the chainsaw in a safe way on the floor, pull
the starting rope firmly.
Do not start the engine while the chainsaw is held with one hand. The chain could touch your
body. This is very dangerous..
5. When the engine makes an attempted start or it starts up, pass the air´s handle to (b) position
(normal position of work).If it has not started, pull the starting rope again until the engine starts
up.
6. Once the chainsaw is running, leave the engine to operate at high acceleration during a few
seconds. Then release the throttle trigger, leaving the chainsaw at idle speed.
Keep the chain clean and away from obstacles, since it will begin to turn when the engine is
functioning.
C. STOP THE ENGINE
1. Release the accelerator trigger to allow the engine to be at
idle speed.
2. Place the switch at "O" position (STOPPED).
32
Switch