miniland baby digimonitor 2.4" Manual Del Usuario página 26

5.3. TROUBLESHOOTING
PROBLEM
Power light does not
come on
High pitched noise
No sound
Power red LED is
flashing
Interference or poor
reception
There is no connection
between the units.
(Link red LED is flashing)
Other malfunctions
POSSIBLE CAUSE
Parent unit: Unit is not
turned on.
Power adaptor is not
plugged in or batteries
are too low.
Baby monitor: Unit is not
turned on.
Power adaptor is not
plugged in or batteries
are too low.
Both units are too close
together.
Volume on parent unit is
set too low.
Batteries are low.
Mobile or cordless
phones are too close to
the baby monitor.
The units are out of
range
The units are not linked
Contact the MINILAND technical service
26
SOLUTION
Slide the Power button
(13) up
Plug in power adaptor or
replace the battery pack
with a new one.
Press and hold the
Power button.
Plug in power adaptor
or replace the batteries
with a new one.
Move parent unit away
from the baby monitor.
Adjust the parent unit
into acceptable volume
level.
Adjust the volume to
highest level.
Replace batteries
Move those phones
away from baby monitor.
Move the units closer
Please check "Pairing
the units" section