Fitting With Standard Allen Screws Din912 - Rebel BTR170 Manual De Instrucciones

Adjusting the position of the anvil in relative to the mandrel
• The position of the anvil depends on the length of the insert before setting.
• The position of the anvil should be adjusted as shown in figure 5.
• After adjustment, tighten the anvil locknut (2) to 10 Nm.
Flush mandrel on the end of the insert
Fitting with standard Allen screw DIN912:
M3
M4
COMMON
M5 ADAPTATOR
7994575
M6
M8
36
OPEN INSERT
Figure 5 - Adjustment of the anvil position
2
3 1
4
5210085.25
5210085.03
5210085.04
5210085.05
5210085.06
SEALED INSERT
Thread root single-turn mandrel
COMMON ADAPTATOR
4
3
5063121.03 0320345.1
5063121.04 0320455.1
5063121.05 0320560.1
5063121.06 0320665.1
NA 0320865.1
1