Ordering Accessories; Warranty And Support; Troubleshooting - Philips HD6569 Manual Del Usuario

Compliance with standards
This machine complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
The energy consumption of this machine in off mode is less than 1 watt.
This means that this machine complies with European Directive 2005/32/EC,
which sets the ecological design requirements for energy-using products.

Ordering accessories

To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).

Warranty and support

If you need information or support, please visit www.philips.com/support
or read the international warranty leaflet.
Recycling
- This symbol means that this product shall not be disposed of with
normal household waste (2012/19/EU) (Fig. 1).
- Follow your country's rules for the separate collection of electrical and
electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.

Troubleshooting

This chapter summarizes the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
Troubleshooting
Problem Solution
The CALC light You have pressed the 1-cup button and the 2-cup
flashes. button at the same time. This started the descaling
cycle. If you did not intend to start the descaling
cycle, simply press the on/off button to switch off the
machine. If you did intend to start the descaling cycle,
do not interrupt this cycle but let the machine operate
until the water reservoir is empty.
The CALC light The descaling procedure has not been completed.
lights up Perform the descaling procedure. Do not switch off
continuously after the machine during descaling.
descaling.
Water continued The machine was performing the flushing cycle. You
to flow from the have to place a bowl of 1.5 liters under the spout.
spout when I used
the machine for
the first time.
The light ring Make sure that there is enough water in the water
around the on/off reservoir and that the water reservoir is placed
button continues properly.
to flash rapidly.
There is not enough water in the water reservoir
(i.e. above the MIN level if you want to brew 1 cup).
Check if the float in the water reservoir is stuck. Empty
the water reservoir and shake it a few times to release
the float. Clean the water reservoir with hot water and
some washing-up liquid or in the dishwasher.
I cannot open A temporary vacuum has developed under the lid.
the lid. Switch off the coffee machine. Pull up the lever and
wait 24 hours before you open the lid. You may need
to use some force. Always make sure the pod holders
are clean and the sieve is not clogged to prevent
vacuum.
The coffee For Intensity Select models only: You may have
machine produces double-pressed the 1-cup or 2-cup button. If you do
less coffee than so, the machine brews a short strong coffee.
before.
Check the pod holder. If the sieve is clogged, use a
washing-up brush to unclog the sieve. If you cannot
clean it properly with the washing-up brush, put the
pod holder in the machine and descale the machine
(see CALC).
Descale the machine (see CALC).
Water leaks from Make sure that you do not overfill the water reservoir.
the machine.
Check that you place the water reservoir on the
machine correctly.
Check the pod holder. If the sieve is clogged, use a
washing-up brush to unclog the sieve. If you cannot
clean it properly with the washing-up brush, put the
pod holder in the machine and descale the machine
(see CALC).
Problem Solution
Make sure that the coffee pod has been put properly
in the center of the pod holder.
In all other cases, contact the Philips Consumer Care
Center in your country.
I cannot close the Check if a used coffee pod is sticking to the water
lid properly. distribution disk. If this is the case, remove the
used pod.
Check if you used the correct pod holder. Use 2 pods
in combination with the deeper 2-cup pod holder.
The SENSEO® For Intensity Select models only: If you want stronger
coffee is not coffee, double-press the 1-cup or 2-cup button to
strong enough. brew a short strong coffee.
Make sure that you place the coffee pod(s) properly
in the center of the pod holder and ensure the coffee
in the pod is evenly distributed.
If you prefer a more robust flavor, SENSEO® coffee
pods with a stronger blend are available.
The SENSEO® For Intensity Select models only: You may have
coffee is too double-pressed the 1-cup or 2-cup button. If you do
strong. so, the machine brews a short strong coffee.
If you prefer a milder flavor, SENSEO® coffee pods
with a milder blend are available.
The coffee is not Do not use cups that are too large, as they cause the
hot enough. coffee to get cold more quickly. Make sure the cups
have a capacity of at least 150ml.
The machine has Contact the Philips Consumer Care Center in your
been stored in a country.
room that was not
frost-free.
Tips and instructions
Flush the machine before first use and if the machine has not been used for
one day. After the flushing cycle (which only takes approx. 2 minutes), the
machine is ready for brewing SENSEO® coffee.
- To brew strong short coffee, double-press the 1-cup or 2-cup button
(HD6569, HD6563).
- While the machine is heating up, you can select the number of cups you
want to brew. The machine brews the cup or cups immediately after it
has heated up.
- You can stop the brewing cycle at any time by pressing the same button
(1-cup button or 2-cup button) that you pressed to start brewing coffee.
2x descaling, 2x rinsing
Descale the machine when the CALC light goes on. Use Senseo descaler
only. The descaling procedure consists of a descaling cycle and two flushing
cycles. Use a used pod in the 1-cup pod holder during the first descaling cycle
and use another used pod in the 2-cup pod holder in the second
descaling cycle. Do not interrupt the descaling cycle and do not switch off
the machine before you have performed the two flushing cycles. The CALC
light continues flash until the descaling procedure is completed correctly.
For more information on why it is important to descale, when to descale
and how to descale or which descaler to use, visit our website at
www.philips.com/descale-senseo.
DANSK
Introduktion
Tillykke med dit køb, og velkommen til Philips! For at få fuldt udbytte af den
support, Philips tilbyder, skal du registrere dit produkt på www.philips.com/
welcome.
SENSEO®-kaffesystem
Få en helt særlig kaffeoplevelse med SENSEO®. Dette enestående system
kombinerer Philips' brugervenlige SENSEO®-kaffemaskine med
de specialudviklede SENSEO®-kaffepuder, der giver en fyldig, rund smag
med et lækkert skumlag. De praktiske SENSEO®-kaffepuder og Philips'
unikke SENSEO®-bryggesystem passer perfekt sammen og sikrer, at den
bedste smag og aroma trækkes ud af kaffen. Se alle SENSEO®-
kaffeblandingerne på www.senseo.com. For at være sikker på at få den
fyldige og runde smag skal du huske følgende:
Rent koldt vand
Brug rent, koldt vand hver dag. Hvis du ikke har brugt maskinen i én dag,
skal du skylle den igennem med rent, koldt vand, før du bruger den igen.
Du skyller maskinen igennem ved at fylde vandtanken med rent, koldt vand,
sætte en skål eller 2 kopper under udløbet og trykke på knappen med
2 kopper nogle få gange for at brygge varmt vand, indtil vandtanken er tom.