JB Systems LED Rotogobo Manual De Instrucciones página 6

ENGLISH
EXCHANGING A GOBO
The logo projector accepts metal gobos, glass gobos and self-printed gobos (laser printer). Ø = 28mm
 Switch off the main supply and unplug the unit.
 Unscrew the 2 knobs (8) on the bottom of the enclosure to open the gobo compartment.
 Remove the fixation ring of the gobo. You can do this easily with a small screwdriver.
 Remove the gobo and insert the new gobo.
 Always put the gobo between the 2 metal gobo protection rings
 Press the fixation-ring together and insert it in front of the gobo.
 Make sure that the end of the fixation ring locks in the groove of the gobo holder.
 Close the gobo compartment again.
 Done!
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
Power consumption:
Fuse:
Power linking (IEC in / out):
LED Source:
Beam Angle:
Gobo Size:
Size:
Weight:
You can download the latest version of this user manual on our website: www.jb-systems.eu
JB SYSTEMS
®
100-240Vac, 50/60Hz
70 Watt
250V 2A slow blow (20mm glass)
max. linking load = 10A
60 W white
18°
External diameter = 28mm / Image size = 23mm
236x234x206mm
3.4 kg
Every information is subject to change without prior notice
4/24
USER MANUAL
LED ROTOGOBO