oneConcept 10033030 Manual Del Usuario página 16

EN
16
4 Shut the bottom of the dust bin again. The fastener must audibly lock into
place.
5 Insert the dust bin in the device: Take hold of it by the handle and insert
the bottom of the bin in the device first. Then push the handle against the
device housing until the dust bin audibly locks into place. Hold the device
by the handle and lift it to check whether the dust bin is properly seated.
Cleaning the dust filter
The dust filter is located in the dust bin.
1 Remove the suction hose from the dust bin.
2 Push the release button on the dust bin and pull it out of the device by
the handle.
3 Turn the dust bin cover to remove it.
Note: Orientation marks for the removal and placement of the cover are
provided on the cover and dust bin. You can remove the cover when the
mark on the dust bin is pointing towards the open lock symbol on the
cover.
4 Pull the dust bin cover with the dust filter out.
5 Open the dust bin cover by using the lever to push it up.
6 Take out the dust filter and the foam dust filter. If necessary, rinse the
foam dust filter out thoroughly with clean, lukewarm water.
Note: Do not in any case clean the filter in the washing machine or
dishwasher! Then shake off any remaining water and let the filter air dry
completely before reinstalling it.
7 Place the dust filter back in the dust bin cover and close it. The lever must
audibly lock into place.
8 Place the dust filter cover with the dust filter back in the dust bin and turn
it until firmly tightened. The cover is properly in place when the mark on
the dust bin is pointing towards the closed lock symbol on the cover.
Note: Insert only dry filters into the unit.