Little Giant VCMA Serie Manual Del Propieratio

Little Giant VCMA Serie Manual Del Propieratio

Bombas de condensado
Ocultar thumbs Ver también para VCMA Serie:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

OWNER'S MANUAL
VCMA Condensate Pump Series
This pump automatically removes condensate water that drips from an air conditioner evaporator coil,
refrigeration equipment coil, condensing furnace, or condensing boiler. The pump is controlled by a float
switch mechanism, which automatically starts and stops the pump.
Some models also include a high-water level switch, which opens a
thermostat circuit when the pump reservoir is full, stopping produc-
tion of condensate. Alternatively, this switch can be reconfigured to
close a circuit, which can operate an external alarm or relay, (pur-
chased separately).
This product is covered by a Limited Warranty for a period of 12
months from the date of original purchase by the consumer. For
complete warranty information, refer to www.LittleGiant.com.
Specifications
Model
VCMA-15
VCMA-20
VCMA-20
SAFETY INSTRUCTIONS
Before Getting Started
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Little Giant recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product's application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Risk of death, personal injury, or property damage due to explosion,
fire, or electric shock.
• Do not use to pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged or electri-
cally disconnected.
• If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected application of
power.
Volts
HZ
115
60
115
60
230
50/60
Amps
Watts
1.0
60
1.5
93
0.5
75
EN
English
Shut Off
15' (4.6 m)
20' (6.1 m)
17' (5.2 m)
Tabla de contenido
loading

Resumen de contenidos para Little Giant VCMA Serie

  • Página 7: Serie De Bombas De Condensado Vcma

    El hecho de no cumplir con los códigos eléctricos y de plomería nacionales y locales y con las recomendaciones de Little Giant puede provocar peligros de descarga eléctrica o incendio, desempeños insatisfactorios o fallas del equipo.
  • Página 8 INSTRUCCIONES SOBRE SEGURIDAD Antes de empezar Riesgo de lesiones graves o muerte por descarga eléctrica. • Para reducir el riesgo de descarga eléctrica, desconecte la energía antes de trabajar en el sistema o cerca de él. • Cablee el sistema de bombeo para los voltajes correctos. •...
  • Página 9: Instalación

    INSTALACIÓN Instalación fisica INSTALACIÓN Instalación fisica 1. Instale la bomba sobre una superficie plana y nivelada con la entrada debajo del drenaje de la bobina, asegurándose de no bloquear las rejillas de ventilación alrededor de la car- casa del motor. •...
  • Página 10: Cableado Del Interruptor Auxiliar De Nivel De Agua Alto

    INSTALACIÓN Conexiones eléctricas • Verde/amarillo = conexión a tierra; Marrón = línea; Azul = línea (230 V) o neutro (115 V) IMPORTANTE: Si el cable de alimentación está dañado, se debe reemplazar la unidad en su totali- dad. Cableado del interruptor auxiliar de nivel de agua alto Riesgo de lesiones corporales o daños materiales.
  • Página 11: Prueba De Operación

    MANTENIMIENTO Prueba de operación Prueba de operación 1. Desconecte la bomba de la fuente de alimentación. 2. Quite el conjunto de la cubierta del tanque. • La cubierta hace un chasquido en el depósito. • Jale hacia afuera la ranura ubicada en el lado más largo de la parte superior.
  • Página 12: Solución De Problemas

    Solución de problemas Problema Causas probables Acción correctiva La bomba no está conectada a la Conecte la bomba a un circuito GFCI dedicado. alimentación. Disyuntor apagado o sin fusible. Encienda el disyuntor o reemplace el fusible. La bomba no arranca Acumulación de residuos o acu- Limpie el flotante;...

Este manual también es adecuado para:

Vcma-15Vcma-20

Tabla de contenido