Care And Maintenance; Troubleshooting - HAMPTON BAY PG139HDS Manual Del Usuario

Care and Maintenance

□ To obtain the best performance from your heater make sure you perform the following maintenance activities on a
regular basis:
a. Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning
agents. Keep the area around the burner and control assembly dry at all times.
b. Keep airflow unobstructed. Clear insect nests or webs away from your heater's exterior and interior.
c. Carbon deposits may create a fire hazard. Clean the dome and emitter with warm soapy water if required.
d. Check your heater for signs of damage or wear and replace components as necessary.
e. Periodically check the hose located within the confines of the cylinder housing for damage.
f. Keep the ventilation clear and free from combustible materials, gasoline and other flammable vapors and liquids.
g. Keep the ventilation openings of the cylinder enclosure free and clear from debris.
h. Visually check the burner flame against the illustration below.
1. Flame should be blue with slight yellow tips.
2. Light the burner and rotate the knob from HIGH to LOW. You should see a smaller flame in the LOW position
than seen on HIGH. Always check the flame prior to each use. Perform a flame check prior to each use. If only
low flame is seen, refer to the "Troubleshooting" section.

Troubleshooting

Problem Possible Cause
The burner does 1. The gas pressure is low.
not light. 2. The orifice is blocked.
3. The control knob is not in the "ON" position.
The burner flame is 1. The gas pressure is low.
low. 2. The control knob is not positioned at "High".
3. The burner jet may be partially blocked.
4. Outdoor temperature is less than 40° F and
5. The supply hose is bent or kinked.
There is carbon A build-up of carbon can accumulate over time.
build-up.
There is thick black There is a blockage in the burner.
smoke.
High
Low
the tank is less than 1/4 full.
Corrective Action
1. Turn the tank valve "OFF" and replace the
tank.
2. Clear the blockage.
3. Turn the control knob to "ON".
1. Turn the tank valve "OFF" and replace the
tank.
2. Position the control knob at "High".
3. Clear blockage.
4. Use a full tank.
5. Straighten the hose.
Wipe off before lighting.
Remove blockage and clean the burner inside
and outside.
17
Please contact 855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM