Lighting Instruction - HAMPTON BAY PG139HDS Manual Del Usuario

Lighting Instructions
□ Turn the LP gas tank valve OFF. Push the control
knob in, turn OFF, and wait 5 minutes for any gas
to clear.
□ Turn the tank valve ON. Push the control knob in
and rotate to PUSH. Then push the igniter button
and control knob until the burner is ignited. If the
burner fails to remain lit or becomes extinguished,
repeat this step after 5 minutes of complete shutoff
period before relighting.
□ Once the burner has lit, continue to hold the control
knob in for 30 seconds, and then release.
□ Turn the control knob from LOW to HIGH to the
desired heat setting.
For complete shutdown:
□ Turn the knob to the "Push" position first, then push
and turn to the "Off" position for complete shut off.
□ Turn the LP gas tank valve OFF before removing
the LP gas tank.
□ If you are unable to ignite the heater using the
above instructions, insert a match through the hole
on the bottom of the burner diffuser to reach the
burner.
WARNING:
If at any time you are unable to light the burner and
smell gas, wait 5 minutes to allow gas to dissipate
before attempting to light the heater.
WARNING:
DO NOT touch or move the heater for at least 45
minutes after use. Allow emitter and dome to cool
before touching.
CAUTION:
Avoid inhaling fumes emitted from the heater's first
use. Smoke and odor from the burning of oils used
in manufacturing will appear. Both smoke and odor
will dissipate after approximately 30 minutes. The
heater should NOT produce thick black smoke.
HIGH
16
Igniter
push
PUSH PILOT
LOW
OFF
Fig.16