AKO 52067 Instrucciones página 9

Pushbutton assembly
The pushbutton should be installed inside the coldroom, in a visible place and no higher than 125 cm from the
floor.
AKO-52062
-Remove the pushbutton's cover (Fig. 4).
-Drill the hole for the included gland needed for the cable entry following the pre-stamped centres on the bottom
of the base.
-Drill 3 holes on the wall following the fixing holes. (Fig. 5).
-Fasten the gland onto the base.
-Insert the 3 screws+plugs through the base, into the 3 holes on the wall and tighten.
-Insert the cables into the gland and connect them according to the wiring diagram.
-Insert the cover and gently press it until you hear a "click".
FIG. 4
Press gently
Fixing holes suitable for
universal built-in housing
AKO-520622
Fix to the wall using the holes for this purpose (A),
connect it to the alarm station by following the
wiring diagram and close the lid with screws
included.
Cable gland is included for cables between 6 and
12 mm Ø.
Recomended installation
The cable must make a 180º bend after exiting from the bottom of the pushbutton (as seen in the image) to prevent
water from reaching the wires.
180º
Max. Ø 3,7
FIG. 5
35 125,5
171
B
B
9
5206H701 Ed.03
Fixing hole detail
A
A
180º