Versions And References - AKO 52067 Instrucciones

AKO Electromecànica thanks you and congratulates you on the purchase of our product, the development and manufacture of which involved
the most innovative technologies, as well as rigorous production and quality control processes.
Our commitment to achieving customer satisfaction and our continuous efforts to improve day by day are confirmed by the various quality
certificates obtained.
This is a high performance, technologically advanced product. Its operation and the final performance achieved will depend, to a great extent,
on correct planning, installation, configuration and commissioning. Please read this manual carefully before proceeding to install it and
respect the instructions in the manual at all times.
Only qualified personnel may install the product or carry out technical support.
This product has been developed for use in the applications described in the manual. AKO Electromecànica does not guarantee its operation
in any use not foreseen in this document and accepts no liability in the case of damage of any type which may result from incorrect use,
configuration, installation or commissioning.
Complying with and enforcing the regulations applying to installations where our products are destined to be used is the responsibility of the
installer and the customer. AKO Electromecànica accepts no liability for damage which may occur due to failure to comply with these
regulations. Rigorously follow the instructions described in this manual.
Whenever a malfunction of the device can cause personal or material damages, the fitter and maintenance staff are responsible for applying
the necessary preventive and protection measures to prevent them. In the same way, the correct operation of the device must be periodically
checked.
In order to extend the lifetime of our products to the maximum, the following points must be observed:
Do not expose electronic equipment to dust, dirt, water, rain, moisture, high temperatures, chemical agents or corrosive substances of any
type.
Do not subject equipment to knocks or vibrations or attempt to handle them in any way differently to that indicated in the manual.
Do not under any circumstances exceed the specifications and limitations indicated in the manual.
Respect the indicated environmental conditions for operation and storage at all times.
During installation and on completion of this, avoid the presence of loose, broken or unprotected cables or cables in poor condition.
These may constitute a risk for the equipment and its users.
AKO Electromecànica reserves the right to make any modification to the documentation and the product without prior notification.
1.- Introduction
Optical and acoustic alarm for low temperature or controlled atmosphere cold stores, consisting of a alarm station
for mounting outside the room and a pushbutton to request help from inside.

2.- Versions and references

MODEL
AKO-52067 Alarm station
Alarm station
AKO-52068
AKO-520671
AKO-52062
AKO-520622
AKO-52067
BASIC
AKO-52062
Pushbutton A
DESCRIPTION
+ Pushbutton A
+ Pushbutton B
Alarm station
Pushbutton A
Pushbutton B
AKO-52068
BASIC
7
BUTTON INCLUDED
AKO-52062
AKO-520622
-
-
-
BASIC
AKO-520622
Pushbutton B
5206H701 Ed.03
POWER SUPPLY
230V~ ± 10%
50/60 Hz
-
-
AKO-520671