Hoover BHTD H7A1TCE-S Manual De Instrucciones página 68

A furniture plinth may be run
l
across the front of the dryer,
but its height will be dictated by
the front kickplate.
Plinth must have ventilation
slots (min. Side/diameter 127
mm hole) according to the
dimensions on fixing template.
If the plinth is not high enough
to accommodate the whole
hole, cut only part of it.
Place the template onto the
l
reverse of plinth. Mark the
screw hole positions, then drill
out these positions (figure 11).
Fix the plinth to the kickplate
l
using 6 screws provided (J).
Note: it's possible only some
types of kickplate (eg. wood or
plastic). We suggest to check
with the kitchen supplier.
Fix the kickplate to the dryer.
l
In case of using full door, door
l
must have min. Ø 127 mm hole
across the slots of kickplate
(figure 12).
WITHOUT the airflow
ventilation hole in the furniture
door/plinth we cannot guarantee
the correct
the appliance.
functionality of
11
12
68