HAMPTON BAY 51012 Guía De Uso Y Cuidado página 8

Assembly - Close-To-Ceiling Mount
1
Close-to-Ceiling Mounting
□
Remove the canopy ring (K) from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
□
Remove the two non-slotted screws and loosen the slotted
screws.
□
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three studs.
Assembly - Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35lbs. (15.9kg) or less", and use screws provided with the
outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting bracket on the outlet box by sliding
the mounting bracket (A) over the two screws (UU) provided with
the outlet box. If necessary, use leveling washers (not included)
between the mounting bracket (A) and the outlet box. Note that
the flat side of the mounting bracket (A) is toward the outlet box.
When using close-to-ceiling mounting, it is important that the mounting bracket be level.
□
Securely tighten the two mounting screws (UU).
A
C
L
K
2
Routing the wires
□
Remove three of the six screws and lock washers (every other
one) securing the motor collar (M) to the top of the fan motor
housing (D).
□
Place the rubber gasket (EE) over the remaining three screws,
route the wires exiting the top of the fan motor through the
canopy ring (K) (make sure the slot opening is on top), then
proceed to place the ceiling canopy (C) over the collar at the
top of the motor (D).
□
Align the mounting holes with the holes in the motor (D) and
fasten, using the three screws and lock-washers removed
previously. Tighten the mounting screws securely.
K
UU
8
C
EE
D
UU
A