Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE: Recommended mounting height is 48"
from the floor to the bottom of the dispenser.
If using template, recommended mounting
height is 48" from floor to bottom of piece of
paper. (See Figure 5)
1. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 5)
Figure 5
2. Using a 6mm drill bit, drill into wall about 1½" at
each marked screw location on template.
(See Figure 6)
Figure 6
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition, as
enclosed hardware may not be compatible
with your wall surface.
NOTE: Paper towel roll should be inserted into
the dispenser with the black core insert on the
right hand side of the roll.
1.
Push left roll holder arm to the left and insert black
core into the right holder arm. Release left holder
arm slowly to ensure that paper towel roll core fits
properly into left holder arm. (See Figure 9)
PAGE 2 OF 12
MOUNTING INSTRUCTIONS
48"
LOADING INSTRUCTIONS
3. Remove template from wall. Insert wall anchors
(if necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert screws into circular base of top two
holes but do not tighten completely. Drop dispenser
down so screws slide up into narrow slots and tighten
screws completely. (See Figure 7)
Figure 7
4. Ensure the dispenser is level by looking at the level
bar on the inside of the dispenser. If level, screw in last
two screws into the bottom two holes. (See Figure 8)
Figure 8
x 2
Figure 9
Left Holder
Arm
1
1
2
Core
2
Right Holder
Arm
0320 IH-5805
Tabla de contenido
