Pressalit Care RK1010 Funcionamiento Y Mantenimiento página 10

Electrical lift units
3
6
c
6
5
2
5
d
5
5
6
6
7
e
5
5
6
6
7
8
8
9
10
10
Lift unit for
worktop and
wall cabinet with
safety rail/plate,
cannot be height-
adjusted
1
5
5
6
6
7
5
5
6
6
7
8
8
9
10
Fault in safety system. The worktop/wall cabinet cannot run up
or down if the safety rail/plate is defective.
Check that all wires and plugs are intact
and correctly connected according to the
installation guide.
Installation error on
Use measurement device
safety rail/plate.
to detect current. Measure current on the
wires from the safety rail/plate and their
plug (a close function).
- if there is current, the safety device
system is working. The lift units should
now run up/down. REMEMBER to reset.
- if no current can be detected:
a. remove the plastic corners on the safety
rail, and slacken the screws at both ends.
The rail should now move freely. Note
that the rail's freedom to move can be
hindered by dirt or grease.
Check for current once more:
If there is current, the safety device
system is working. If no current can be
detected, see under "Faulty switches".
b. slacken all screws on the safety plate
until it can move freely. Note that the
plate's freedom to move can be hindered
by dirt or grease.
Check for current once more:
If there is current, the safety device
system is working. If no current can be
detected, see under "Faulty switches".
Faulty switches. Check whether one or more of the safety
system contacts is sticking, and if so,
attempt repair . If the problem cannot be
fi xed, replace the contact(s). The safety
system will only work when current can be
detected. REMEMBER to reset.
Jumper missing If there is a combination in which one of
in safety device box. the safety inputs in the safety device box
is not in use, that input must be fi tted with
a jumper lead. If a jumper lead is missing,
the worktop will not run, although the wall
cabinets will run up and down correctly.
See installation guide.
When jumper lead and other safety device
plugs
worktop and wall cabinet will run up and
down correctly.
Note that in some instances, 2 safety
device boxes are used
marked 8-9-10.
If the lift units run up/down correctly, all
safety systems are working correctly.
REMEMBER to reset.
c
(ohmmeter)
d
(mk. 5 and 6) are inserted, both
e
, of which one is