Pressalit Care RK1010 Funcionamiento Y Mantenimiento página 18

Manual lift units
37
38
39
40
18
Faultfi nding
Wall-mounted
Fault
Lift unit does not run
synchronously.
The lift unit does not move
when the hand crank is
turned.
NB!
5
Freestanding
Fault
Lift unit does not run
synchronously.
5
The lift unit does not move
when the hand crank is
turned.
Contact Pressalit Care or your dealer if the problem cannot
be remedied. Do not attempt to repair the product yourself,
as this will invalidate the guarantee.
Cause
The telescopic legs are
not mounted at the same
height (not level).
The crank is not correctly
fi tted on the drive shaft.
The extension rod is not
correctly attached to the
angle gear .
The angle gear is not
correctly attached to the
longitudinal drive shaft
between the two telescopic
legs.
Cause
The telescopic legs are
not mounted at the same
height (not level).
The crank is not correctly
fi tted on the drive shaft.
The extension rod is not
correctly attached to the
angle gear .
The angle gear is not
correctly attached to the
longitudinal drive shaft
between the two telescopic
legs.
Remedy
Run the unit as far down
to its lowest position as
possible. Detach the
longitudinal shaft on the side
where the leg is highest.
Insert an Allen key into the
leg and turn until the leg is
fully retracted.
Push the crank down as far
as it will go and turn until
the worktop moves up and
down.
Connect the rod correctly
to the gear .
(See installation guide).
Connect the gear correctly
to the drive shaft. (See
installation guide).
Remedy
Run the unit as far down
to its lowest position as
possible. Detach the
longitudinal shaft on the side
where the leg is highest.
Insert an Allen key into the
leg and turn until the leg is
fully retracted.
Push the crank down as far
as it will go and turn until
the worktop moves up and
down.
Connect the rod correctly to
the gear . (See installation
guide).
Connect the gear correctly
to the drive shaft. (See
installation guide).