Akasa elite Manual De Usuario página 12

FAQ
FAQ
1. Does the enclosure need any drivers in USB mode?
The embedded drivers of Windows 2000/XP/VISTA/7 control the enclosure in USB
mode via mass storage device driver strategy and there are no additional drivers
required.
2. Does the enclosure need any drivers in eSATA mode?
The motherboard's SATA drivers control the enclosure in eSATA mode and there are
no additional drivers required.
3. When do I need to format the HDD?
The HDD should only be formatted if it is brand new or you want to use an old
HDD with different file format.
4. Is there a HDD limitation?
No, all capacity of SATA I and SATA II hard drives are supported
5. Do I need to restart the system if connecting the enclosure via USB?
No, when using the USB connection the enclosure is Plug and Play.
6. Do I need to restart the system when connecting the enclosure via eSATA?
Most motherboards don't support Hot Swap on eSATA/SATA connection but
some do. Please refer to your motherboard manual.
7. My system doesn't have an eSATA port, can I still use the enclosure?
You can use the enclosure in USB mode or equip you PC system with a SATA to eSATA
adapter / SATA to eSATA cable and your Notebook with an eSATA expansion card.
8. Can I use any power adapter with the enclosure?
No, only the supplied power pack can be used. Some power adapters may have
similar connectors but the Voltage and pin layout might be different.
Using an unsuitable power pack will result in damage to the HDD and enclosure.
9. Will my HDD overheat if left on for a long period of time?
No, to prevent the hard drives from overheating the body of the enclosure is made of thick
aluminium, which enhances heat dissipation. Avoid keeping the enclosure near a radiator
or in direct sunlight.
10. I've connected the enclosure via eSATA but it does not appears in explorer.
Make sure the motherboard eSATA/SATA port is enabled in BIOS. Restart the system.
If you have any more questions please contact as at: [email protected]