Scott PURSUIT 350 Manual Del Usuario página 7

TYPE A & B
4
Stands for the size of the protectors and is applicable
to all joint impact protectors. Type A refers to the
standard dimensions of protection for the average
user. Type B has an additional wider area of protec-
tion compared to type A
LEVEL
The performance is based on the amount of impact transmission measured in kN (kilo Newton).
The EN 1621-2:2014 provides 2 Levels of protection: Level 1 and Level 2. According to EN 1621-
5
2:2014 : Level 1 protectors shall have an average peak force below 18kN and each single strike shall
not exceed 24kN Level 2 protectors shall have an average peak force below 9kN. and each single
strike shall not exceed 12kN.
The EN 1621-1 (shoulder, elbow, knee, hip, leg) standard provides 2 Levels of protection: Level 1
6
and Level 2. Level 1 protectors shall have an overall mean value below 35kN, each single strike shall
not exceed 35kN in the area I, and 50kN in the area II and III. Level 2 protectors shall have an overall
mean value below 20kN, each single strike shall not exceed 20kN in the area I, and 30kN in the area
II and III.
Level 2 protectors offer higher performance than Level 1 protectors.
Level 2 protectors offer the highest Level specified by the CE standard. Due to the extra Level of
protection Level 2 protectors may be heavier, thicker and less ergonomic than the Level 1 protectors.
It is up to the responsibility of the rider to choose the correct Level of protection according to their
needs, their experience, their performance and skills.
TEMPERATURE
7
T+ means the protection is tested and certified for temperatures up to +40 degrees Celsius
T- means the protection is tested and certified for temperatures down to –10 degrees Celsius
All SCOTT protections are certified with ambient and wet conditioning. Wet conditioning testing is
used to simulate the high humidity experienced during sports.
• VII. HOW TO ADJUST YOUR PROTECTOR
CHOOSING YOUR CORRECT SIZE
It must be chosen in reference to the size indicated in the following
size chart or on the garment itself. SCOTT Sports SA shall not accept
any complaints arising from the use of an incorrectly fitted protector.
TORSO LENGTH 39-44 cm 15.35''-17.32'' 42-47 cm 16.53''-18.5'' 45-49 cm 17.71''-19.29''
CHEST
PROTECTION LOCATION
BACK PROTECTOR AND CHEST POSITIONING
For a protector to work properly, it must cover the protected area correctly. The gar-
ment must be the correct size, chosen from the manufacturer's size chart. All SCOTT's
protectors are designed to stay firmly in contact with the body.
To obtain maximum adherence to the protected area the protector must be worn
under tear proof clothing. Belts, straps or elastic bands (see drawing below) should be
fastened tightly to guarantee stability of the garment during use without being uncom-
fortable for the user. Check the entire closure system, including gripping bands and the
correct placement of the vest before use. Wear, dirt or any kind of damage may com-
promise their efficiency.
M
cm inch
85-95 cm 34''-37''
A
A
I II
L
cm inch
95-105 cm 37''-41''
B
B
III I II III
XL
cm inch
105-115 cm 34''-42''
7 - ENGLISH