jbc DR560-A Manual De Instrucciones página 5

w w w.jbctools.com
Changing the heating element
(Ref. DSV-DR)
For this operation, turn off the station or disconnect the tool and wait until the tool temperature
drops to room temperature.
1. Removing
Loosen the deposit lid (a),
remove the screw (b)
and withdraw the heating
element (c).
2. Placing
b
c
Insert the new Heating
Element (a), tighten the screw
(b) and then the lid (c).
! Before placing, make sure
a
to insert the internal gasket
!
into the Glass Solder Collector.
Important
For a proper connection
it is essential to insert the
cartridge by lining it up to
the mark .
Compatibility
washer
The DSV-DR also works with
the previous version DR5600
Desoldering Iron (Ref. 5600010).
In this case, you must take out
the washer with a pliers.
5