Cleaning And Maintenance; What If There Are Problems; Disposal - Beurer BY 52 Instrucciones Para El Uso

• Shake the bottle or stir the food in the jar.
• Check that it is the correct temperature.
• To prevent the breeding of bacteria, which multiply fastest in the temperature range from around
32°C to 42°C, please use the heated baby food as soon as possible.
• We do not recommend keeping the food warm for any longer, as this can cause important vita-
mins to be lost.
• For hygienic and microbiological reasons, do not reheat food that has already been heated.
• Take care not to overheat food/liquids.

8. Cleaning and maintenance

The service life of the device depends on its careful handling:
• To extend the service life of the device, we recommend that it is not (continuously) operated in the high
temperature range.
• Use boiled or filtered water for warming baby food. This will reduce the build-up of lime scale.
• Unplug the device before cleaning.
• To clean the device, use only a damp cloth. Do not use any scouring agents or other cleaning products.
• Descale the device using vinegar or citric acid. Place the lifter in the device, mix 50 ml of household vinegar
with 100 ml of cold water or a packet of citric acid with 200 ml of cold water and pour this solution into the
device. Leave the solution to work until the lime scale has been removed; do not operate the device during
this time. Pour the liquid away, rinse the device out thoroughly and finally dry it with a cloth.
• Descale the device approx. every four weeks.

9. What if there are problems?

Fault
Water leaks from the bottom of
the device when in use.
The warming process does not
start or does not end.
No LED display
The baby food warmer does not
switch on once it is plugged in.
The temperature on the display
does not increase once the warm-
ing process is started; the device
switches itself off after a while.
The food is not warm at the end
of the warming process.

10. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.
Cause
Device faulty
Thermostat broken
Mains plug not (correctly)
plugged in or device faulty
No electricity
No water in the device
Not enough water in the device
13
Action
Switch off the device immedi-
ately, unplug it, let the water
drain out and return the device
to the retailer.
Switch off the device immedi-
ately, unplug it, let the water
drain out and return the device
to the retailer.
Check that the mains plug is
(correctly) plugged in. If there
is still no display, switch off the
device, unplug it and return it to
the retailer.
Check that the mains plug is
correctly plugged in.
Unplug the device, let it cool
down, then fill it with water and
start the warming process as
described in these instructions.
Unplug the device, let it cool
down, then fill it with sufficient
water and start the warming
process as described in these
instructions.