Setting Up Your Cd Clock Radio; Using Ac Power; Using Battery Backup - Insignia NS-C2116 Guia Del Usuario

Setting up your CD clock radio

Using AC power

To use AC power:
1 Make sure that your local AC power source matches the voltage
shown on the plate located inside the battery compartment (120 V
60 Hz). If it does not, consult your dealer or service center.
2 Connect the power cord to the AC connector on the CD clock
radio, then plug it into an AC power outlet.
3 To switch the CD clock radio off completely, unplug the power cord
from the AC power outlet.
Caution

Using battery backup

Your CD clock radio has a battery backup feature that continues to
operate the electronic clock if the AC cord is disconnected or if there
is a power failure. The clock operates internally, with no display.
Check the condition of the battery periodically by disconnecting the
AC cord and reconnecting it again several minutes later. The clock
should maintain the correct time, even when the power is
disconnected. During a power outage, if the power is not restored for
longer than 30 minutes, the battery must be replaced and the time
reset.
To install the battery:
• Open the battery compartment and insert a 9V battery,
preferably alkaline. Make sure to match the polarity indicated
by the "+" and "-" markings on the snap-on battery terminal.
Caution
• Use only the size and type of battery specified in this
• Remove the battery if the CD clock radio will not be used
• Do not try to recharge a non-rechargable battery. The
10
To protect your CD clock radio during heavy thunderstorms,
unplug the power cord from the AC power outlet.
Incorrect use of batteries can cause electrolyte leakage and
can corrode the compartment or the batteries. To prevent
this damage:
guide.
for an extended period of time.
battery can overheat and rupture.
www.insignia-products.com
Insignia NS-C2116 CD Clock Radio