Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Proper hand position requires one hand on the main handle
as shown in figure E.
1
Fig. E
On/Off Switch
•
To switch the tool on, depress the on/off switch
the "I" position.
•
To switch the tool off, depress the on/off switch
the"O" position.
Operation
WARNING: Let the tool work at its own pace. Do
not overload.
Grasp the sander and turn it ON. Move it in long, sweeping
strokes along the surface, letting it do the work. Pushing
down on the tool while sanding actually slows the removal
rate and produces an inferior quality finish.
Check your work often. This sander is capable of removing
material rapidly.
Dust Collection (Fig. F, G)
WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can selfignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
•
The dust bag
5
should be emptied after every 10
minutes of sanding.
•
To attach the dust bag to the sander, line up the
grooves
9
on the side dust bag collar
bag locks
11
on the dust port
•
Slide the dust bag
5
dust bag clockwise to lock it in place as shown in the
insert of Figure F.
•
To remove, turn the dust bag
slide the dust bag off.
•
To empty the dust bag, remove it from the dust port
and dump the sanding debris into an appropriate trash
receptacle Figure G.
10
with the dust
4
.
onto the dust port and turn the
5
counterclockwise and
Fig. F
5
Fig. G
at
2
2
at
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
Accessories
WARNING: Since accessories, other than those offered by
PORTER-CABLE, have not been tested with this product, use
of such accessories with this tool could be hazardous. To
reduce the risk of injury, only PORTER-CABLE recommended
accessories should be used with this product.
A complete line of accessories is available from your
PORTER-CABLE Factory Service Center or a PORTER-CABLE
Authorized Warranty Service Center. Please visit our Web
Site www.portercable.com for a catalog or for the name of
your nearest supplier.
9
4
10
English
11
9
Tabla de contenido
Solución de problemas
