Tabla de contenido
Idiomas disponibles
Idiomas disponibles
<Setting the Serial Number>
Before proceeding, make sure that the WB 8000RW and D 8000 are within 17 feet (5m) of each other.
The serial number must be set in order for the WB-8000RW and the D-8000 to communicate.
The same assigned serial number should be set for the WB-8000RW as for its corresponding D-8000.
This must be performed when using the device for the first time, or when using the D-8000 with a different WB-8000RW. If it is not performed,
measurement values will not be displayed on the D-8000.
d
d
d
d
d
d
d
d
d
1. Press
on the D-8000 .
2. When "Func1" appears, press
3
"Pin1" will be displayed.
[When configuring the WB-8000RW for the first
time]
You can register up to 4 WB-8000RWs in
advance.
Press
to select the Pin* number you
wish to register (Pin1 to Pin4), and press
*Pin : Preset Input Number
4
When the top half of the LCD blinks, press
to enter the 5 digit number printed
on the bottom of the WB-8000RW (see figure
below). Press
to move to the next
number.
5. After entering every digit, press
6
When "donE" appears, the configuration process is complete.
* To register a different serial number with a different Pin, repeat the process from step 1.
* The D-8000 cannot be connected simultaneously to multiple WB-8000RWs. To measure using a
different WB-8000RW, set the correct Pin and then perform the measurement.
* To register a different serial number for a Pin to which a serial number has already been
assigned, overwrite the existing serial number with the new serial number, and press
.
[When configuring a WB-8000RW which has
previously been registered]
When the Pin number of a WB-8000RW whose
serial number has previously been registered
is displayed, the top half of the LCD will show
the registered serial number.
.
Press the
Pin number (5 digit serial number), and press
.
.
Press
.
keys to select the desired
.
3
Tabla de contenido
