Troubleshooting - Kobalt A081002 Manual Del Usuario

SERVICE
Servicing requires extreme care and knowledge and should be performed only by a qualified
service technician. For service, it is suggested you return the product to your nearest AUTHORIZED
SERVICE CENTER for repair. When servicing, use only identical replacement parts.
STORAGE
• Run the snow thrower for a few minutes in order to melt any snow that may be left on the snow
thrower.
• Wipe the snow thrower off with a dry cloth before storage. This will help prevent ice building up on
the unit and parts freezing.
• Inspect the snow thrower thoroughly for worn, loose, or damaged parts. If any parts must be
repaired or replaced, contact 1-888-356-2258.
• Store the snow thrower in a clean, dry place. Cover it in order to provide added protection.

TROUBLESHOOTING

If you still have questions or an unresolved issue after going through this troubleshooting guide, or
just want to speak to a Kobalt product expert, please call our Kobalt customer service department
at 1-888-356-2258.
PROBLEM
The handle is not in
position.
The snow thrower
doesn't start.
The motor is on, but the
impeller does not turn.
The snow thrower
leaves a thin layer of
snow behind.
POSSIBLE CAUSE
1. The bolts are not
properly seated.
1. Unplugged power
supply.
2. The switch is defective.
1. The belt is damaged.
1. The scraper is worn.
CORRECTIVE ACTION
1. Make sure the bolts are correctly
installed through the handle bars.
Check to see if the hand knobs are
tight. Refer to Assembling the Handles
section in this manual.
1. Plug the power supply.
2. Have the switch replaced by an
authorized service center.
1. Replace the belt (see the section
entitled Replacing the Belt).
1. Inspect the scraper for wear or
damage. Replace the scraper (see the
section entitled Replacing the Scraper
Bar).
18