Troubleshooting Guide - AirKing Seville Serie Manual De Operación

Wire Compartment
Figure 5
2. Attach the wire compartment to the power unit with two of the provided
#6 blunt tipped screws (Figure 5).
SECTION 5
Finishing the Installation
1. Remove any protective plastic adhered to the power unit.
2. Install two MR16, GU10 Base 50W maximum Halogen lamps by inserting
lamp into socket and turning clockwise slightly until firmly seated. DO NOT
over tighten.
3. Turn switches to the OFF (
light and the fan are operating properly.
4. If there is any vibration noise, check for the source and try to tighten
fasteners or adjust the tape to make a tighter connection or seal.
SECTION 6
Operation
Controls
Your Range Hood is equipped with two sliding switches with one controlling the
lighting and the other controlling the exhaust fan. The light control has two
positions, ON (I) and OFF ( 0 ). The fan is a four position control, HIGH (III), MEDIUM
(II),LOW (I), and OFF ( ) (Figure 6).
Figure 6
Trouble
1. Hood does not operate when the switch is on.
2. Hood is operating, but air moves slower than normal.
3. Hood is making a rattling noise.
6728012 Rev. B 5-09
) position and restore power. Test that the

Troubleshooting Guide

Probable Cause
1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker.
1b. Wiring is not connected properly.
2. Obstruction in the exhaust ducting.
3a. Filters are loose.
3b. Duct connection is loose.
SECTION 7
Maintenance
CAUTION:
BEFORE SERVICING THE UNIT.
Filters
1. Included with your unit are aluminum grease filters that should be washed
at least once a month. The filters are dishwasher safe and should be
washed in a mild soap or detergent.
2. To remove the filters, pull down on the handle tab until the filter releases
from the unit. To reinstall, slide tab at rear of filter into slot in the unit. While
holding in handle of filter, lift filter into place and release handle. The filter
should snap securely into place (Figure 7).
Figure 7
NOTE: If your model is equipped with a filter screw, slide tab at rear of filter into
slot in hood and secure filters in place by tightening screw located at front of
filter. DO NOT OVERTIGHTEN.
3. If the grease filters become damaged, replace with the Air King Model
BCGF-01 Grease Filters.
Cleaning
CAUTION:
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1. Clean your power unit with a mild detergent, such as dishwashing liquid,
and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING
POWDERS. Completely dry before restoring power. NEVER IMMERSE
ELECTRICAL PARTS IN WATER.
2. The fan assembly can be vacuumed when build up (dirt, lint, etc.)
accumulates over time. The fan is permanently lubricated and does not
require oiling.
Suggested Remedy
1b. Turn off power to unit. Check that all wires are connected.
2. Check for any obstructions in the ducting including filter.
3a. Turn off power to unit. Check that all filter screws are fully tightened.
3b. Turn off power to unit. Check that duct connection is tight.
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL
Tab
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
3 of 12