Tabla de contenido
Idiomas disponibles
Idiomas disponibles
White from Lamp
White from Motor
Figure 5
NOTE: DO NOT disconnect any wiring that has already been crimped
with a wire connector from the factory.
2.
Replace the wire compartment cover and tighten screw. Make sure
all wiring is securely contained within the wire compartment.
Ducting
(if applicable)
CAUTION:
ALL DUCTING MUST COMPLY WITH LOCAL AND
NATIONAL BUILDING CODES.
1.
Your range hood comes ready for ductless operation, and no
additional ducting is required.
Finishing the Installation
1.
Install the appropriate filter sliding the back side of the filter into
the tab and pressing the front of the filter into place (Figure 6).
Figure 6
Trouble
1. Hood does not operate when the switch is on.
2. Hood is operating, but air moves slower than normal.
3. Hood is making a rattling noise.
6728001 Rev. A 2-05
2.
3.
Operation
Controls
Your Range Hood is equipped with two rocker style switches with one
Hot (Black)
controlling the lighting and the other controlling the exhaust fan. The
light switch has two positions, ON (
position switch, HIGH (
Ground
position of the switch.
Maintenance
CAUTION:
PANEL BEFORE SERVICING THE UNIT.
Filters
Grease/Charcoal Filter - Your range hood is equipped with a combination
grease/charcoal filter. This filter cannot be washed and must be discarded
and replaced when it has become noticeably dirty, has stopped filtering
the odors, or at least once per year. Replace with Air King Model RF55
Combination Odor/Grease Filter.
Cleaning
CAUTION:
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1.
2.
Troubleshooting Guide
Probable Cause
1a. A fuse may be blown or a circuit tripped.
1b. Wiring is not connected properly.
2. Filter needs replacing.
3a. Motor is loose.
3b. Filter is loose.
www.airkinglimited.com
Turn switches to the "OFF" position and restore power. Test that
the light and the fan are operating properly.
If there is any vibration noise, check for the source and try to
tighten fasteners.
), LOW (
MAKE SURE POWER IS SWITCHED OFF AT SERVICE
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
Clean your range hood with a mild detergent, such as dishwashing
liquid, and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS
OR SCOURING POWDERS. Completely dry before restoring power.
NEVER IMMERSE ELECTRICAL PARTS IN WATER.
The fan assembly can be vacuumed when build up (dirt, lint, etc.)
accumulates over time. The fan is permanently lubricated and does
not require oiling.
Suggested Remedy
1a. Replace fuse or reset circuit breaker.
1b. Turn off power to unit. Check that all wires are connected
2. Check filter for build up and replace if necessary.
3a. Turn off power to unit. Remove filter, check that all screws are
fully tightened.
3b. Turn off power to unit. Check that filter is tight.
) and OFF (
). The fan is a three
), and OFF. OFF is the middle
3
Tabla de contenido
Solución de problemas
